IBPS Bank and UPPSC UPSSSC signature size

What size does the IBPS Bank and UPPSC UPSSSC signature need to be

The IBPS Bank and UPPSC UPSSSC forms want the signature at 140 by 60 pixels, saved as a JPG, with the file somewhere between 10 and 20 KB. At 300 DPI that works out to roughly 1.2 by 0.5 cm on paper. All three conditions have to hold at once. Getting the pixels right will not help if the file is the wrong weight, and a file of the right weight fails if the dimensions are off. The portal checks each one separately and the error message it shows rarely tells you which one failed.

What the shape means for cropping

140 by 60 pixels is a ratio of 7:3, which is a wide strip. A photo taken on a phone is 3:4 and taller than it is wide. It cannot fill a strip this wide without losing a large part of the top and bottom, which is why this page opens with the option that keeps the whole image and pads the sides in white. Open More controls above if you want to switch between cropping the edges to fill the frame and keeping the whole image with white space around it.

Why the range is 10 to 20 KB

People tend to read only the upper limit and compress the file as small as it will go. That is the single most common mistake. A file under 10 KB is rejected exactly as firmly as one over 20 KB, because the portal tests both ends. This tool searches for the best quality that still fits under 20 KB, and if the result lands below 10 KB it lifts the file back into range without altering a single pixel. The ceiling is generous for an image this small. Files here tend to come out under the minimum rather than over the maximum, and the tool lifts them back into range when that happens.

How to do it

Tap the box above and pick your image. The preset is already set to IBPS Bank and UPPSC UPSSSC signature, so the width, height and KB range are filled in and you do not need to type anything. Press Resize. The result appears below with a three line checklist covering pixel size, file size and format. Green against all three means the portal will accept it. Then press Download JPG and upload that file to the form.

Doing it on a phone

Put the signed paper on a flat surface and hold the phone directly above it rather than at an angle, or the signature comes out skewed. Turn the flash off. It blows out the paper and flattens the ink. Natural light near a window works best. Once you have the shot, tap the box above, pick it from your gallery, and the resized file goes straight to Downloads.

What your original needs to be

The target here has a long edge of 140 pixels. Anything from a phone camera in the last decade is far bigger than that, so you have room to spare. Aim for an original with a long edge of at least 280 pixels and the result stays sharp. What you must avoid is feeding in something already smaller than 140 by 60, because scaling an image up cannot invent detail that was never captured. That is why a crop from a group photo, or a screenshot, tends to look soft no matter what you do to it afterwards.

Which exams this covers

These dimensions apply across PO, Clerk, SO, RRB; UP state exams. The bodies running them keep the signature specification consistent between its papers, so one correctly sized file usually serves every form you fill under it that season. Save the 140 by 60 version you download here and you can reuse it, but check each notification anyway, because a single paper occasionally departs from the standard.

How to produce the signature

Sign on plain white paper with a black or dark blue pen. Avoid pencil and light coloured ink, which barely register once the image is compressed. Sign larger than you normally would, because a small signature looks smaller still after it has been scaled down. Photograph it in daylight and make sure no shadow from your hand or phone falls across the paper. Keep the paper straight rather than at an angle.

Use the same signature everywhere

The signature you upload has to match the one you put on the OMR sheet and the attendance sheet on exam day. If they do not match, your candidature can be cancelled. Use your ordinary everyday signature rather than inventing a neater one for the form.

If the upload is still rejected

Read your notification again and check the numbers against this page. Exam bodies revise them between cycles, and the 140 by 60 px and 10 to 20 KB shown here reflect a previous notification. If your notice says something different, type those numbers straight into the width, height and KB boxes above, which are all editable. If it still fails after that, try a different browser, and try renaming the file. Some portals quietly reject file names containing spaces or special characters.

Common questions

Related sizes

• IBPS Bank and UPPSC UPSSSC photo size — 200×230 px, 20–50 KB
• IBPS Bank thumb impression size — 240×240 px, 20–50 KB
• IBPS Bank declaration size — 800×400 px, 50–100 KB
• SSC signature size — 400×200 px, 10–20 KB
• UPSC signature size — 350×350 px, 20–300 KB
• NEET JEE signature size — 400×200 px, 4–30 KB